Etek Labs USB Devices Driver

12/14/2021by admin
Ryan-Scott posted this 12 March 2013 - Last edited 03 January 2018

Etek Labs Usb Devices Driver Vga

  1. Right Click on the 'USB-EPP/I2C.CH341A' device and select Unistall' from the drop down menu. After the device is removed you can turn the power off and them back on on the laser cutter. When the computer detects the laser cutter on power up the original driver will be restored and you can use the original (LaserDRW) software again.
  2. Etekcity® USB 3.0 SuperSpeed Universal Laptop Docking Station with Dual Video Outputs, Resolution up to 2048x1152, Gigabit Ethernet, Audio, 2 USB 3.0 Ports, 4 USB 2.0 Ports Drivers & Downloads OS10.10-OS10.9-OS10.8 win10-win8.1(32bit-64bit)-win7(32bit-64bit).

For the Aeon Labs Z-stick GEN5:

Etek Labs Usb Devices Driver Updater

Labs

Windows Drivers: http://aeotec.com/z-wave-usb-stick/1358-z-wave-drivers.html

For the Aeon Labs ZStick 2:
Firmware: http://aeotec.com/partner/z-wave-firmware/viewcategory/5-z-stick-2nd-edition
Windows Drivers: http://www.silabs.com/Support%20Documents/Software/CP210x_VCP_Windows.zip
Aeon Labs USB LITE:
Firmware: http://aeotec.com/partner/z-wave-firmware/viewcategory/6-z-stick-lite
Windows Drivers: http://www.silabs.com/Support%20Documents/Software/CP210x_VCP_Windows.zip

Etek Labs Usb Devices Drivers

Download Silicon Labs CP2103 USB to UART Bridge VCP Driver 6.6.1 (Other Drivers & Tools). Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported. The device implements a virtual serial interface used by the Z-Wave application. Linux and Mac OSX has a built in device driver for the stick and will create a new device named like /dev/ttyACM0 (Linux) or /dev/cu.usbmodemfa131 (OSX). Windows enumerates a new COM port device but might require a device driver uzb.inf available below.

Comments are closed.